| Internet-Draft | IP fragmentation on UDP Sockets | November 2024 |
| Seemann | Expires 19 May 2025 | [Page] |
When performing Path MTU Discovery (PMTUD) over UDP, applications must prevent fragmentation of UDP datagrams both by the sender's kernel and during network transit. This document provides guidance for implementers on configuring socket options to prevent fragmentation of IPv4 and IPv6 packets across commonly used platforms.¶
This note is to be removed before publishing as an RFC.¶
Discussion of this document takes place on the Transport and Services Working Group Working Group mailing list ([email protected]), which is archived at https://mailarchive.ietf.org/arch/browse/tsvwg/.¶
Source for this draft and an issue tracker can be found at https://github.com/marten-seemann/draft-seemann-tsvwg-udp-fragmentation.¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 19 May 2025.¶
Copyright (c) 2024 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶
[RFC0791] defines the Don't Fragment (DF) bit in the IPv4 header. When set, this bit prevents routers from fragmenting IP packets. If a router needs to fragment a packet with the DF bit set, it will instead drop the packet and send an ICMP "fragmentation needed" message back to the sender.¶
The DF bit has historically been most relevant to TCP ([RFC9293]), where the kernel handles Path MTU Discovery (PMTUD) internally. Applications using TCP sockets do not need to interact with the DF bit directly.¶
In IPv6 ([RFC8200]), fragmentation by intermediate nodes is not permitted. All IPv6 packets effectively have the DF bit set, however, the endpoint's kernel might still break up UDP datagrams that are too large to fit the MTU of the interface before sending a packet into the network.¶
[RFC8899] defines Datagram Packetization Layer Path MTU Discovery (DPLPMTUD), a mechanism that allows protocols running over UDP to determine the maximum packet size they can send. Setting the DF bit is crucial for DPLPMTUD, as it ensures that packets larger than the Path MTU are dropped, allowing the endpoint to detect the MTU limitation.¶
QUIC [RFC9000] is one such protocol that runs over UDP and make use of DPLPMTUD. As QUIC implementations typically run in user space, they need to configure the DF bit on their UDP sockets to perform DPLPMTUD correctly.¶
This document provides guidance for implementers on how to set the DF bit on UDP sockets across different platforms.¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶
While routers don't fragment IPv6 packets in transit, the sender's kernel will still fragment UDP datagrams that are too large to fit the MTU of the interface before sending a packet into the network. Therefore, operating systems offer socket options to control the fragmentation behavior for IPv6 packets.¶
For user-space implementations of DPLPMTUD, applications need to set the DF bit on IPv4 sockets and prevent fragmentation on IPv6 sockets.¶
Linux uses the socket option of level IPPROTO_IP with name IP_MTU_DISCOVER with value IP_PMTUDISC_DO for IPv4.¶
For IPv6, IPV6_MTU_DISCOVER with a value of IPV6_PMTUDISC_DO is used for the IPPROTO_IPV6 level.¶
For dual-stack sockets, both socket options can be set independently.¶
For IPv4, Apple platforms use the socket option of level IPPROTO_IP with name IP_DONTFRAG with value 1. For IPv6, IPV6_DONTFRAG with value 1 is used for the IPPROTO_IPV6 level.¶
However, dual-stack sockets are handled differently: To open a dual-stack socket, an IPv6 socket needs to be opened and the IPV6_V6ONLY option needs to be set to 0. This enables the socket to send both IPv4 and IPv6 packets. IPv4 packets must be sent using an IPv4-mapped IPv6 address.¶
When using a dual-stack socket, it is only necessary (and possible) to set the IPV6_DONTFRAG socket option. This results in the DF bit being set when sending IPv4 packets. It is not possible to control the fragmentation behavior of IPv4 and IPv6 separately.¶
For IPv4, Windows uses the socket option of level IPPROTO_IP with name IP_DONTFRAGMENT with value 1. For IPv6, IPV6_DONTFRAG with value 1 is used for the IPPROTO_IPV6 level.¶
Similar to the Apple platforms, dual-stack sockets are IPv6 sockets with the IPV6_V6ONLY option set to 0. IPv4 packets must be sent using an IPv4-mapped IPv6 address. However, contractary to Apple platforms, the DF bit on IPv4 packets is controlled by the IP_DONTFRAGMENT socket option.¶
TODO Security¶
This document has no IANA actions.¶
TODO acknowledge.¶